Cleaning Brush – Compatible for Hydrafacial®Handpiece

$15.00

SKU: A055

Cleaning Brush – Compatible for Hydrafacial® Handpiece, pkg. 1

The HydraFacial® handpiece tubing chambers must be cleaned and disinfected using the cleaning brush every week to prevent any bacte­rial contamination.

Hydrafacial® is a trademark of Hydrafacial®,LLC. MPR is not associated with Hydrafacial®,LLC and HydraFacial®,LLC does not endorse, sponsor, support or associate with MPR or its products. Any reference to HydraFacial®,LLC or us of HydraFacial®,LLC’s trademarks herein is only to describe and identify the products bearing those marks. 

 

 

  • New
  • Brand Name: 1 MPR
  • Part Number: A055

80+ name brands
 to choose from

Serving over 4,500 Med Spas nationwide

Get money for your
old equipment

The HydraFacial® MD handpiece tubing chambers must be cleaned and disinfected using the cleaning brush every week to prevent any bacte­rial contamination.

 

HydraFacial® Handpiece
The HydraFacial® handpiece tubing chambers must be cleaned and disinfected using the cleaning brush every week to prevent any bacte­rial contamination.

Note: Make sure the flow control is fully open (+)

  1. Insert the cleaning brush into the vacuum (smaller) opening.
  2. Insert the cleaning brush into the vacuum (smaller opening) on the face of the hand piece. Push it in gently all the way, while rotating in either  direction. Repeat with the opening on the back with the blue dot. A few drops of disinfectant may be dropped onto the “face” of the hand piece (held in an upright position) allowing the disinfec­
    tant to run into the handpiece opening before inserting the cleaning brush. Note: 70% isopropyl alcohol is not suitable as a disinfectant.
  3. Wash the brush bristles in soapy water between each handpiece
    opening insertion to clean off debris.
  4. Using a compressed air canister with the straw attached, blow air
    first into the vacuum (smaller opening) on the face of the handpiece, and then into the opening in the gray cartridge on the back of the hand piece.
  5. When the brush and air cleaning are completed, make sure all the blue toggle switches are in the OFF position. Turn the gray toggle
    switch “SYSTEM RINSE” up to the ON position and the vacuum set­ting on “26”. Press on the cleaning cap and flush through the hand­piece and tubing for I minute.

Reviews

There are no reviews yet.

Be the first to review “Cleaning Brush – Compatible for Hydrafacial®Handpiece”

Your email address will not be published. Required fields are marked *